NetDev_CfgIntCtrl

This function is called by a device driver’s NetDev_Init() to configure a specific network device’s interrupts and/or interrupt controller on a specific interface.

Files

net_bsp.c

Prototype

          static void NetDev_CfgIntCtrl (NET_IF  *p_if,
                                         NET_ERR *p_err);

Note that since NetDev_CfgIntCtrl() is accessed only by function pointer via a BSP interface structure, it doesn’t need to be globally available and should therefore be declared as ‘static’.

Arguments

p_if

Pointer to specific interface to configure device’s interrupts.

p_err

Pointer to variable that will receive the return error code from this function:

NET_DEV_ERR_NONE
NET_DEV_ERR_FAULT

This is not an exclusive list of return errors and specific network device’s or device BSP functions may return any other specific errors as required.

Returned Value

None.

Required Configuration

None.

Notes / Warnings

Each network device’s NetDev_CfgIntCtrl() should configure and enable all required interrupt sources for the network device. This usually means configuring the interrupt vector address of each corresponding network device BSP interrupt service routine (ISR) handler and enabling its corresponding interrupt source. Thus, for most NetDev_CfgIntCtrl(), the following actions should be performed:

  1. Configure/store each device’s network interface number to be available for all necessary NetDev_ISR_Handler() functions (see function NetDev_ISR_Handler()). Even though devices are added dynamically, the device’s interface number must be saved in order for each device’s ISR handlers to call NetIF_ISR_Handler() with the device’s network interface number.

    Since each network device maps to a unique network interface number, it is recommended that each instance of network devices’ interface numbers be named using the following convention:

    <Board><Device>[Number]_IF_Nbr

    <Board>

    Development board name

    <Device>

    Network device name (or type)

    [Number]

    Network device number for each specific instance of device (optional if the development board does not support multiple instances of the specific device)

    For example, the network device interface number variable for the #2 MACB Ethernet controller on an Atmel AT91SAM9263-EK should be named AT91SAM9263-EK_MACB_2_IF_Nbr.

    Network device interface number variables should be initialized to NET_IF_NBR_NONE at system initialization prior to being configured by their respective devices.

  2. Configure each of the device’s interrupts on either an external or CPU’s integrated interrupt controller. However, vectored interrupt controllers may not require the explicit configuration and enabling of higher-level interrupt controller sources. In this case, the application developer may need to configure the system’s interrupt vector table with the name of the ISR handler functions declared in net_bsp.c.

    NetDev_CfgIntCtrl() should only enable each devices’ interrupt sources but not the local device-level interrupts themselves, which are enabled by the device driver only after the device has been fully configured and started.

    Since each network device requires a unique NetDev_CfgIntCtrl(), it is recommended that each device’s NetDev_CfgIntCtrl() function be named using the following convention:

    NetDev_[Device]CfgIntCtrl[Number]() 

    [Device]

    Network device name or type, e.g. MACB (optional if the development board does not support multiple devices)

    [Number]

    Network device number for each specific instance of device (optional if the development board does not support multiple instances of the specific device)

    For example, the NetDev_CfgIntCtrl() function for the #2 MACB Ethernet controller on an Atmel AT91SAM9263-EK should be named NetDev_MACB_CfgIntCtrl2(), or NetDev_MACB_CfgIntCtrl_2() with additional underscore optional.

See also Network Board Support Package.

Examples