Test Management Interface
NDIT requires a connection with the target to configure the tests. There are two connection protocols available: RS-232 or TCP/IP (Ethernet). The use of TCP/IP requires a functional Ethernet driver and TCP/IP stack. It is common to start with RS-232, when a UART is available.
Upon starting NDIT, the following dialog box appears:
Panel | |
---|---|
|
...
|
...
| |
The connection setup options are as followed:
Connection type
RS-232
COM port (ex: COM1).
Baud rate (8 bits, no parity, 1 stop bit and no flow control)
...