Starting the SystemView Trace Recorder
To start recording you need the host application, SystemViewer, which can be downloaded from the following link: https://www.segger.com/systemview.html
...
- The Target Device name matches your embedded target and the one configured by other tools using the same J-Link session (e.g. Debugger and/or µC/Probe).
- The Target Interface & Speed match the ones supported by your embedded target and the ones configured by other tools using the same J-Link session (e.g. Debugger and/or µC/Probe).
The RTT Control Block Detection setting makes an attempt to locate the symbol
_SEGGER_RTT
where the trace data is stored using one of three methods: automatically or by manually specifying the address and range of_SEGGER_RTT
Recording Status
During the streaming process, you will be presented with a window similar to the one shown below.
...
- Run SystemViewer stand-alone without a debugger and/or µC/Probe.
Further Reading
For additional and more detailed coverage of SystemView refer to SEGGER SystemView Documentation.