Page Comparison

...

Include the following files in your project tree from the µC/TCP-IP source code distribution, as indicated in Figure - µC/TCP-IP Source Code. In this figure, the IP folder only show the sub-folder IPv4 as an example. If you are running with IPv6, please add the IPv6 folder instead or add both IPv4 and IPv6 folders if you want your project to support both IP version. 

As indicated in the Figure - µC/TCP-IP Source Code, all the files in the Source folder must be added to your project tree. Furthermore, if a TCP-IP port exists for your CPU architecture inside the "Ports" folder, you can also include it to your project files. 

...

\Micrium\Software\uC-TCPIP

\Micrium\Software\uC-TCPIP\Dev\Ether\<device_name>

\Micrium\Software\uC-TCPIP\Dev\Ether\PHY\<phy_device_name>

...

Modify Static Configurations

As previously mentionnedmentioned, the µC/TCP-IP static configurations are located in the net_cfg.h file. For this getting started guide, the template file without modification should be enough to get you started. Depending on your Interface device configuration, it is possible that you would need to adjust the µC/TCP-IP queues' configurations as listed in Listing - in Listing µC/TCP-IP Static Configuration Modifications. Refer to section Task Queue Configuration  for more details on the TCP-IP queues' s configurations.configurations.

Tasks Priority

The net_cfg.c file includes the three network task configurations. You will need to defined the priority of each of those tasks. The priorities will depend on the other tasks already present in your application. Refer to section Network Tasks Configuration for all the details on configuring the network tasks and their priority. 

...

Ping (on the PC) should reply back with the ping time to the target. µC/TCP-IP target projects connected to the test PC on the same Ethernet switch or Ethernet cross-over cable achieve ping times of less than 2 milliseconds.

After you have successfully completed and run the example project, you can use it as a starting point to run other µC/TCP-IP demos you may have purchased.

...

#include  <KAL/kal.h>
#include <Source/net.h>
#include <net_dev_????.h>
#include <net_phy_????.h>
#include <net_dev_cfg.h>
#include <net_bsp.h>

Adding µC/TCP-

...

IP Application Function

Before running the example application, you will need to add the new funtion, AppInit_TCPIP(), in your app.c file to initialize and setup the µC/TCP-IP stack. Section Tasks and Objects Initialization gives an example of the main application task inside which the AppInit_TCPIP() function will be called. Section Ethernet Sample Application gives an AppInit_TCPIP() example for a wired Ethernet interface.

...