...
\Micrium\Software\uC-TCPIP
\Micrium\Software\uC-TCPIP\Dev\Ether\<device_name>
\Micrium\Software\uC-TCPIP\Dev\Ether\PHY\<phy_device_name>
...
As previously mentionned, the µC/TCP-IP static configurations are located in the net_cfg.h file. For this getting started guide, the template file without modification should be enough to get you started. Depending on your Interface device configuration, it is possible that you would need to adjust the µC/TCP-IP queues' configurations as listed in Listing - µC/TCP-IP Static Configuration Modifications. Refer to section to section Task Queue Configuration for more details on the TCP-IP queues's configurations.
Tasks Priority
The net_cfg.c file includes the three network task configurations. You will need to defined the priority of each of those tasks. The priorities will depend on the other tasks already present in your application. Refer to section Network Tasks Configuration for all the details on configuring the network tasks and their priority.
Example Project Setup
The purpose of this example project is to setup a network host on the target board to allow it to communicate with other hosts on the network. Figure - Example Application Setup shows the project test setup for a Ethernet wired interface. The target board is wire-connected to an Ethernet switch or via an Ethernet cross-over cable to a Windows-based PC. The PC’s IP address is set to 10.10.10.111 and the target’s addresses will be configure to 10.10.10.64 as it will be shown in the next section Adding µC/TCP-IP application function.
...
Before running the example application, you will need to add the new funtion, AppInit_TCPIP(), in your app.c file to initialize and setup the µC/TCP-IP stack. Section Tasks and Objects Initialization gives an example of the main application task inside which the AppInit_TCPIP() function will be called. Section Ethernet Sample Application gives an AppInit_TCPIP() example for a wired Ethernet interface.
...